ZSA-5A brick bursting cooking box using method - Database & Sql Blog Articles

MOS power IC full range

100V, 250mA, surface mount, high speed switching diode

Probe domestic switch needle KG-300K needle head diameter is 3.0mm normally open switch needle

One-piece inductor

ZSA

-

5A

Brick bursting cooking box

ZSA

-

5A

Brick bursting cooking box

,

This product is in accordance with the country

GB5101

-

85

Designed and manufactured according to the requirements of the brick lime crack test, it can automatically control the water temperature in the tank.

100

°C time, temperature display, time display, liner imported stainless steel plate. It is one of the special equipment for brick and tile production, construction, scientific research and experimental units.

ZSA

-

5A

Brick bursting cooking box

Instructions:

1

,

Put the instrument box in balance, check the same, open the upper cover, fill the water in the cooker, the water level is lower than the rafter

40

Millimeter shall be placed parallel to the side of the brick on the rafter in the cooking box, the interval between the bricks is not less than

50

Millimeter.

2

,

Turn on the power correctly as required, turn on the power switch, and the meter should correctly display the operating temperature, set temperature, and set time.

3

,

Adjust the temperature set value of the temperature controller and the set value of the constant temperature working time. The temperature is set to

98

°C, the time is set to

1

hour

00

Minute. Temperature and time setting: press the "temperature time" button

3

Seconds, the “Set Temperature” window flashes, press the plus or minus button to adjust the set temperature value, then press the “Temperature Time” button, the “Set Time” window will flash, press the plus or minus button to adjust the set timing working time value. Press the “Temperature Time” button again to exit the setting state, or

5

The second does not press the button and exits automatically.

4

,

Working condition: the water in the box is boiling

3

The kilowatt heater is automatically stopped.

1

Kilowatt electric heating pipe in steamed water

1

Stop heating after hours, stop

4

After an hour, turn off the power and remove the test piece.

5

,

After the end of the work cycle, long press the "Reset" button

3

Seconds, the working time is cleared.

6

,

Clean and fresh water must be used in the box. After the equipment is used for a long time, scale may accumulate in the box, and the user may clean it regularly as appropriate.

7

,

If there is a deviation between the measured temperature and the measured temperature, the temperature sensor error can be corrected. For details, please consult our company.