Foreword
Article 4.3 of this standard is mandatory, and the remaining provisions are recommended.
This standard was proposed by the State Economic and Trade Commission and the National Standardization Administration Committee.
This standard is under the jurisdiction of the National Energy Foundation and Management Standardization Technical Committee.
This standard was drafted: China Standards Research Center, Beijing Electric Light Source Research Institute, National Electric Light Source Quality Supervision and Inspection Center (Beijing), National Electric Light Source Quality Supervision and Inspection Center (Shanghai), Nanjing Huadong Electronics Group Co., Ltd., Zhejiang Sunshine Group Co., Ltd. Beijing Songxia Light Source Lighting Co., Ltd., Energy Research Institute of the State Planning Commission.
The main drafters of this standard: Chen Haihong, Zhao Yuejin, Qu Suhui, Moral Ning, Hua Shuming, Yu Anqi, Li Aixian, Liu Wei, Yao Ningying, Hang Jun, Liu Hong.
range
This standard specifies the energy efficiency rating, energy efficiency limit value, energy conservation evaluation value, test method and inspection rules of self-ballasted fluorescent lamps for general lighting (hereinafter referred to as self-ballasted fluorescent lamps).
This standard applies to rated voltage 220V, frequency 50H z AC power supply, nominal power is 60W and below, using screw cap or bayonet lamp head, for general illumination in home and similar occasions, integrating control start and stable ignition parts Self-ballasted fluorescent lights.
This standard does not apply to self-ballasted fluorescent lamps with a cover.
2 Normative references
The terms in the following documents become the terms of this standard by reference to this standard. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this standard. However, parties to agreements based on this standard are encouraged to study whether the latest versions of these documents are available. . For undated references, the latest edition applies to this standard.
GB / T 2828 batch-by-batch inspection sampling procedure and sampling table (for continuous batch inspection)
GB / T 2829 cycle inspection count sampling procedures and tables (for inspection of process stability)
GB / T 17263 Performance requirements for self-ballasted fluorescent lamps for general lighting