Because a long time ago when home decoration did not fully consider the layout of the cable, resulting in the cable only received the study of the corner of the entire house, and the old route signal is particularly bad, my room often only a single signal, the network speed is extremely poor. In desperation to come to ZDM to look at the router, missing the goods that do not find this money. So follow suit on the wind, and learned to brush router firmware.
First of all, I would like to thank everyone on the ZDM for eating crabs first and for writing seniors for the tutorial. In the beginning, I was also prepared to brush it step by step, but as a lazy and incomprehensible white, it would be better if it was simpler. So I searched the Internet and found a post on the forum. Above said that just open a web page, or mobile phone scanning QR code will automatically brush firmware This is simply white welfare. Ah anyway, not money, brush bad to brush bad spirit, I am happy to do a mouse.
Then, when Dangdang ~~~
Is it amazing? Is it that I want to beat me too much?
Or directly from the brush machine method to everyone
1: The router can access the Internet normally and log in to the router (default password admin)
2: Use the browser to open this web site or scan the QR code (default ip 192.168.2.1)
And the original mobile phone brush firmware display
I don't have a sun drying out of the box, after all, everyone has sunburned so many times. (This egg box has a bright sun, everyone sees it)
Or talk about my own experience
Because the route got it, I immediately had the opportunity to flash it, so I couldn't compare it with the original firmware. Then I took FAST FWR200 for a long time to talk about it. The first is the signal. This should be the most obvious improvement. My laptop is in the same position, the signal rises from a bare one to a stable four, and the living room farthest from the study can also find a signal. More exaggerated is that my family lives on the 6th floor, I walked downstairs still separated by a meter to a meter, the phone actually connected to their own wireless, there are two signals I really sorry neighbors around. It seems that the four large antennas are not furnishings.
Second, you can send 5G signals. This need not be natural.
However, I have some misgivings and I still hope the gods will answer them. When watching online before, it was said that the MT7620A's chip may be delayed a bit high. I don't know if this delay will be related to the firmware of the brush. If so, I hope everyone will recommend a firmware. Anyway, on the first day I used it, the frequency of playing games was very serious. I couldn't look at the tens of thousands of delays. Although the next few days were slightly better, the delay was still a bit higher than the old router.
In order to test the delay of the router itself and the influence of signal strength on the delay, I tested it in the study room and in my own room.
study:
Your own room (two walls apart)
In order to ensure the accuracy of the test, I ping 1000 times for both tests and then average the results. It can be seen that in the case of the strongest signal, the delay is still possible. The average value is 1.766ms (some people say it is better than 1ms), and the delay of the delay is relatively stable with the standard deviation. The maximum delay is 40ms. In the case of 3 to 4 cells in their own room, the average delay is 9.237ms. The standard deviation shows a significant increase in beat amplitude, and the maximum delay is 169ms. It can be seen that the effect of signal strength on the network delay is quite obvious.
(I suddenly want to brush OpenWrt's firmware again, I want to dial more bandwidth, I want the router to block ads)